Nyltite Sealing Solutions from PSM International
Nyltite Sealing Solutions are manufactured from extruded thin wall tubing and is designed for applications where locking and sealing is required under the head of the screw. Nyltite can be supplied pre-assembled to fasteners of your specification. Tests have proved that Nyltite will provide superior sealing performance, as well as reducing joint failure caused by vibration. Nyltite headed/ unheaded sleeves are available for electrical applications requiring a high degree of insulation or cable protection.
Insulating spacers are also available.
Advantages
> Seals and locks almost any type of headed screw
> Effectively locks and seals self-tapping screws
> Can be re-used
> Provides electrical insulation between screw and component assembly
> Also prevents electrolytic corrosion in the same area
> Provides sound and vibration isolation
> The seal resists petroleum products, salt water, hot oils, refrigerants, alkalies, diluted mineral acids and most solvents and chemicals
Nyltite Benefits
The Nyltite product does not need any particular preparation of the fastener or work piece and does not require any kind of adhesive.
The Nyltite seal or headed sleeves, combined with any compression fastener (screws, bolts and nuts, rivets, eyelets, pop rivets, nails) offers a cost effective and high performance seal over traditional sealing methods.
As an added advantage, Nyltite offers vibrational dampening through increased torque and against galvanic corrosion of dissimilar material.
For applications which may be subject to ultra violet rays, it is recommended that Nyltite should be specified in black.
The Nylon interface eliminates damage due to surface chipping and crazing of the mating component.
The configuration of this kind of seal makes the nylon flow inwardly under compression, filling all the voids between the fastener and work piece.
Nyltite Sealing Technical Data
Seals
Headed Seals
Unheaded Seals
Seating Torques
Recommended Clearance Holes
